Wagan 2014 - Manual (Page 2)

Quick Flow 3 in 1 Air Compressor by Wagan Tech
USER’S MANUAL — Please read before using this equipment.
________________________________________________________________________________________________________________________________________________________________
www.wagan.com
© 2004 Wagan Corporation.
All Rights Reserved.
Wagan and Wagan.com are trademarks used by Wagan Corporation.
Thank you for purchasing the Quick Flow 3 in 1 Air Compressor by Wagan
Tech. With normal care and proper treatment it will provide years of
reliable service. Please read all operating instructions carefully before use.
AIR COMPRESSOR OPERATION:
• Pull out hose from compartment. Place quick connect chuck over
valve stem of tire with thumb lever in the vertical position. Push
down firmly and lock into place by pressing thumb lever to
horizontal position. Turn compressor's switch on and monitor
pressure using the built-in pressure gauge. DO NOT
OVERINFLATE PRODUCTS BEYOND THE
MANUFACTURER'S RECOMMENDATIONS.
• When desired pressure is reached, turn off compressor and
disconnect hose.
• NOTE: If tire is completely deflated, it is possible that the seal
between the tire and the rim could be broken allowing air to leak
out when trying to inflate. This usually happens only on
completely flat tires. In the event this situation occurs, you will
have to jack up your car prior to inflating the tire. For inflating
other articles, select the appropriate adaptor and insert into the
hose nozzle as shown. Inflate as illustrated.
• NOTE: For athletic balls, moisten needle before inserting it into
the ball valve. For other pneumatic articles, the nozzle should be
inserted into valve and held tightly to insure a good seal.
• CAUTION: NEVER LEAVE COMPRESSOR UNATTENDED
WHILE IN USE.
WORKING LIGHT:
The Quick Flow 3 In 1 Air Compressor comes with a built-in 12V 6W
crypton light for a powerful and bright torch. Once the Quick Flow 3 In 1
Air Compressor is connected to a 12V power outlet, just move the switch to
the LIGHT position for easy use.
EMERGENCY LIGHT:
In case of need, you can use the exchangeable amber colored lens to use the
blinking light as an emergency function. Just move the switch to the
EMERGENCY LIGHT position.
CHANGING THE 12V 6W CRYPTON BULB:
• Unscrew ring from front of light moving anti clockwise.
• Unscrew bulb and replace with a new one.
• Place ring and lens on the unit by turning it clockwise.
CHANGING COLORED AND CLEAR LENSES:
• Unscrew ring from front of light moving anti clockwise.
• Take lens from inside the ring holder and replace for the desired one.
• Place ring and lens on the unit by turning it clockwise.
SPECIFICATIONS:
• Pressure Reader: 260 PSI GAUGE
• Air Hose: 14"
• 12Volt Cord: 125"
•
Accessories: 3 Nozzles, collar, Inflator Nozzle, Sport Needle