Dryer care, Warning, Drying rack option – Whirlpool Duet W10110850A User Manual

Page 23: Cleaning the dryer location, Cleaning the lint screen

Advertising
background image

23

Drying Rack Option

The drying rack is useful for drying items you would not
necessarily want to tumble dry or that you would normally line dry
(for example, sweaters).

If your model does not have a drying rack, you may be able to
purchase one for your model. To find out whether your model
allows drying rack usage and for information on ordering, please
refer to the front page of the manual or contact the dealer from
whom you purchased your dryer.

To use the drying rack

Do not remove the lint screen.

1. Open dryer door.

2. Place drying rack inside dryer drum, positioning the back wire

on the ledge of the inner dryer back panel. Push down on
front edge of drying rack to secure over the lint screen.

3. Put the wet items on top of the rack. Leave space between

the items so air can reach all the surfaces.

NOTE: Do not allow items to hang over the edge of the rack.

4. Close the door.

5. Select a timed drying cycle and temperature, or an air cycle

(see following chart). Items containing foam, rubber, or plastic
must be dried on a clothesline or by using the Air Only
temperature setting.

6. You must select a time by pressing the DRY TIME up or down

buttons. Reset time as needed to complete drying. Refer to
the following table.

7. Press and hold START button (about 1 second).

NOTE: Check the lint screen and remove any lint accumulated
from items dried on the rack.

This chart shows examples of items that can be rack dried and
the suggested cycle, temperature setting and drying time. Actual
drying time will depend on the amount of moisture items hold.

*(Minutes) Reset time to complete drying, if needed.

NOTE: You must remove rack for normal tumbling. Do not use
automatic cycles with the drying rack.

DRYER CARE

Cleaning the Dryer Location

Keep dryer area clear and free from items that would obstruct the
flow of combustion and ventilation air.

Cleaning the Lint Screen

Every load cleaning

The lint screen is located in the door opening of the dryer. The
control panel has an indicator light to remind you to clean the lint
screen before each load. A screen blocked by lint can increase
drying time.

To clean

1. Pull the lint screen straight up. Roll lint off the screen with

your fingers. Do not rinse or wash screen to remove lint. Wet
lint is hard to remove.

2. Push the lint screen firmly back into place.

A. Front edge

A. Dryer rack front edge
B. Dryer back panel

A

A

B

Rack Dry

Setting

Temp.

Time*

Wool Sweaters

Block to shape and lay flat on
the rack.

Timed
Dry

Low

60

Stuffed toys or pillows

Cotton or polyester fiber filled

Timed
Dry

Low

60

Stuffed toys or pillows

Foam rubber filled

N/A

Air Only

(no heat)

90

Sneakers or canvas shoes

N/A

Air Only

(no heat)

90

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as
gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.

Failure to do so can result in death, explosion, or fire.

Advertising