Wibur Curtis Company MCD-7 - Manual (Page 2)

Figure 1. View of MCD-7, looking
into drum.
1. Place a coffee filter or a Brew Basket with filter already inserted. Fit it, into the front
opening of the MCD-7.
2. Pulling the handle will dispense the amount of coffee you have selected with the
foam insert. lf you need to change the quantity of ground coffee that is dispensed
(see FOAM INSTERTS INSTALLATION, above) choose a different size of insert.
OPERATION OF MCD-7
Figure 2. View putting foam inserts
in the drum.
1. Remove lid. Remove bag of inserts.
2. Looking down into the hopper, observe the small nylon pin piercing the left side of the
measuring drum.
3. Now turn unit on its back (see Figure 1.).
4. Using a knife blade or thin screw driver, slide the blade under the head of the pin and pry
out the nylon pin.
5. Pull handle to DOWN position and carefully, place into drum opening, one of the foam in-
serts (as shown in Figure 2.). Each insert is marked with the quantity, in ounces, that it will
dispense (the smaller the insert, the more coffee dispensed from the unit).
6. Replace nylon pin. Press firmly on the head until it snaps into place.
7. Turn unit upright and fill up the hopper with coffee. The coffee dispenser is now ready for
use.
FOAM INSERTS, INSTALLATION
[ 1 ]