Assembly 3 – Disney HANDY MANNY TOT ROD R2510 User Manual
Page 8
Advertising
T3260pr-0920
8
• Locate the wire connector inside the front end of the vehicle.
• While feeding the wire connector through the hole in the dash,
fit the tabs on the dash onto the front end of the vehicle.
Dash
ASSEMBLY
3
Pull
• Turn the vehicle over.
• Remove the protective caps from the ends of the steering
column and throw them away.
• Fit the straight end of the steering column down through the
hole in the dash.
Steering Column
4
BOTTOM VIEW
SIDE VIEW
2
DASH VIEW
• Insert two #8 x ¾
" screws
straight into the dash, as
shown. Tighten the screws.
Hint: If the screw holes in the dash do not align with the vehicle,
place a finger in the steering wheel opening in the dash. Pull the
dash toward the back of the vehicle to reposition it.
Wire Connector
Advertising
This manual is related to the following products: