Weider WEBE03820 - Manual (Page 8)

8
11. Tap a Fly Arm Stop (15) onto the welded tube on
each Upright (1).
Press two Plastic Bushings (14) into the indicated
holes in an Upright (1). Attach a Fly Arm (25) to
the Upright using an M10 x 115mm Bolt (19) and
a Butterfly Knob (13). Make sure the Fly Arm is
on the outside of the Fly Arm Stop (15). Do not
overtighten the Butterfly Knob; the Fly Arm
must be able to pivot easily.
Attach the other Fly Arm (not shown) to the
other Upright (1) in the same manner.
12. Push a 19mm Round Inner Cap (9) into the end
of a Short Pad Tube (12). Slide the Short Pad
Tube as far as it will go into the indicated hole in
the a Fly Arm (25), as shown. Slide a Short Foam
Pad (27) onto the Pad Tube.
Repeat this step for the other Fly Arm (not
shown).
13. Route the eyelet end of the Cable (39) through
the hole in the Lat Tower (40) and over the Pulley
(44). Attach the Pulley, two Spacers (43), and two
M10 Washers (34) to the Lat Tower with an M10 x
55mm Bolt (42) and an M10 Nylon Locknut (33).
Press a 38mm Square Inner Cap (21) into the top
of the Lat Tower (40).
Insert two Square Bushings (47) into the top and
bottom of the Weight Carriage (48). Press two
25mm Round Inner Caps (24) into the ends of the
weight tube on the Weight Carriage. Slide two
Weight Stops (28) onto the weight tube.
Slide an M8 x 16mm Screw (45) into the bracket
on the Weight Carriage (48).
Slide the Weight Carriage (48) onto the Lat Tower
(40). Attach the Cable (39) to the M8 x 16mm
Screw (45) with an M8 Nylon Locknut (17).
13
14
25
14
15
19
1
1
12
13
27
9
12
25
21
39
33
42
34
34
40
39
17
28
28
24
24
48
47
Bracket
47
45
43
43
44
11