White Outdoor Z - 165 - Manual (Page 28)

28
Figure 24
12. Turn the pulley counterclockwise until the belt is completely off of the pulley.
13. Locate the clutch pulley. It is located in the rear of the tractor, below the muffler. (See Figure 25)
14. Remove the belt from the clutch pulley.
Figure 25
WARNING: Exhaust and surrounding engine parts are very hot and can cause severe burns when
touched.
15. From the front of the Z-series, pull the mower deck towards you. This will release the retaining arms from the
mower deck. There are two retaining arms one for each side of the deck. (See Figure 26)
16. Lift and hold the retaining arms up.
Figure 26
Bracket
J Pin
Jam Nuts
Retaining
Arm
Retaining
Bracket
Attached to frame of tractor