WhisperKool Extreme 8000 - Manual (Page 17)

Page 17
Exterior Grille Installation
The exterior grille is required on all installations where the condenser side of the unit is exposed to the outside
of the dwelling (i.e. rain and weather).
The condenser grille must be removed. Locate the screws at the bottom of the grille and remove. Using me-
dium force, push the grille upward and lift the grille away from the unit. Replace the bottom screws and tighten
the upper screws.
Now determine at what depth the unit will be installed:
• For a non-flush installation (i.e. holes location #1 WhisperKOOL retrofit or #2 Middle Wall), place the grille
on the condenser end and line up the holes on the grille with the holes on unit location #3. Use the 10
screws provided to fasten the grille to the unit.
• For a flush installation, place the grille on the condenser side and then place the mounting bracket over
the grille sides, “stacking” them. Align the holes and fasten with the 10 screws provided.
INSTALLATION OPTIONS
Non-Flush Installation Flush Installation