Weider WEMC07730 - Manual (Page 9)

This section explains how to adjust the resistance system accessory. Make sure all parts are properly tightened
each time the resistance system accessory is used. Replace worn parts immediately. The resistance system
accessory can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents.
USING THE LEG LEVER
To use the Leg Lever (9), attach it to the Leg (14) with
a Leg Station Pin (B). Slide a Cotter Pin (A) onto the
Leg Station Pin.
Route the hook end of the Leg Lever Cable (S) under
the Pulley (R) in the Leg (14), and attach it to the Leg
Lever (9).
Make sure the hook is oriented as
shown when attaching it to the Leg Lever. Insert a
Leg Station Pin (B) into the Leg, under the Cable.
Slide a Cotter Pin (A) onto the Leg Station Pin.
See the inset drawing. Attach a long end of the Leg
Lever Cable (S) to one end of the lower cable (T) with
a Cable Clip (U).
Attach the other long end of the
Leg Lever Cable to the other end of the low cable
in the same manner.
To perform the leg extension exercise, the indicat-
ed Pad Tube (5) should be inserted through the Leg
(14) as shown.
To perform the leg curl exercise, remove a Large
Foam Pad (7) from the Pad Tube (5). Remove the
Pad Tube and insert it through the hole in the Leg
Lever Bumper (L). Slide the Large Foam Pad back
onto the Pad Tube.
ATTACHING THE CURL PAD
To attach the Curl Pad (4), insert the Curl Post (3)
into the Leg (14). Secure the Curl Post with the Curl
Knob (12).
Remove the Curl Pad (3) from the resistance sys-
tem when performing an exercise that does not
require it.
U
S
S
T
B
B
A
Hook
14
L
R
7
5
9
ADJUSTMENTS
A
9
12
3
4
14