Weider WESY38321 User Manual
Page 13
13
24. Route the Lat Cable (88) over a 3 1/2” Pulley (78).
Slide a plastic Long Cable Trap (102) onto a 3/8” x
1 3/4” Bolt (93). Attach the Pulley to the indicated
bracket on the Top Frame (6) with the Bolt and a
3/8” Nylon Locknut (113). Make sure that the Long
Cable Trap is turned to hold the Cable in the
groove of the Pulley.
25. Remove the preassembled 3/8” Nylon Locknut (87)
and 3/8” x 2” Bolt (100) from the Pulley Plates (63).
Wrap the Lat Cable (88) under a 3 1/2” Pulley (78).
Attach the Pulley and a Cable Trap (68) between
the indicated holes in the Pulley Plates (63) with the
3/8” x 2” Bolt (100) and the 3/8” Nylon Locknut (87).
Make sure that the Cable Trap is turned to hold
the Cable in place.
26. Attach the end of the Lat Cable (88) inside of the
Butterfly Top Frame (7) with a 5/16” x 2 1/2” Bolt
(59), two 5/16” Washers (90), and a 5/16” Nylon
Locknut (86).
27. Locate the Butterfly Cable (69), which is the
shortest Cable. Attach the Cable to the Pivot
Bracket (70) on the Left Butterfly Arm (25) with a
5/16” x 1” Shoulder Bolt (103) and a 5/16” Nylon
Locknut (86).
27
24
25
26
78
88
113
93
6
68
63
87
78
88
88
90
86
90
59
7
86
69
103
70
25
100
63
102