Weider WEBE64410 - Manual (Page 6)

1. Before assembling this product, make sure you
understand the information in the box above.
Identify the Right Upright (1) by the position of
the adjustment brackets. Press a 51mm x 76mm
Square Inner Cap (24) into the top of the Right
Upright.
Press a 2” Square Inner Cap (17) into each end of
the Right Stabilizer (26).
Insert four M10 x 62mm Carriage Bolts (33) up
through the Right Stabilizer (26).
(Note: On one side
of the Stabilizer there is an indentation around
each hole. Insert the Bolts from this side.) Place
the Right Stabilizer flat on the floor.
Slide the Right Upright (1) onto the four M10 x 62mm
Carriage Bolts (33) in the Right Stabilizer (26). Attach
the Upright with four M10 Nylon Locknuts (11).
Set the Right Upright (1) aside, making sure that it
cannot fall.
1
6
33
1
11
11
17
33
26
17
24
Adjustment
Brackets
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
The following tools (not included) are required
for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Things Easier for Yourself
This manual is designed to ensure that the
weight bench can be assembled successfully
by anyone. Most people find that by setting
aside plenty of time, assembly will go smoothly.
ASSEMBLY