Waterford Precision Cycles Built-in 70 - Manual (Page 14)

Manual defrosting and cleaning of freezer
chamber;
It is recommended to defrost the freezer chamber
at least once a year.
Set the temperature control dial to “9” for four hours
prior cleaning. This will allow storing the frozen
food at room temperature for a longer period of
time.
Stop the appliance compressor by setting the tem-
perature control dial to “0”.
Unplug the mains lead from the wall socket.
Wrap the drawers in paper (newspaper can be
used) and in a blanket.
Store the wrapped drawers in a cool place.
Place a bowl containing hot water (not boiling) in
the chamber to speed up defrosting. The defrosting
of the appliance should last as little time as possi-
ble.
Manual defrosting and cleaning of refrigerator
chamber;
It is recommended to clean the appliance at least
once a month.
Unplug the mains lead from the wall socket.
Stop the refrigerator compressor by setting the tem-
perature control dial to “0”.
Remove all the shelves and drawers and wash the
chamber wall with warm water (never use boiling
water) and a little washing up liquid.
Wash all accessories by hand only, they are not
dishwasher safe.
Clean the water drain using the cleaning pin sup-
plied (See Fig.)
13
Dry with a soft cloth.
Do not use an electric heater, heating fan or hair
dryer to aid defrosting under any circumstances.
Place a flat dish or the freezing tray on the floor
against the bottom of the appliance to collect water
from the channel at the bottom of the freezer cham-
ber.
When defrosting is complete, clean the freezer
chamber with warm water and a little washing-up
liquid.
Dry with a soft cloth.
Grease or oil should never be used on door seals
as these will cause them to deteriorate and become
porous over time.
The door seals should be cleaned regularly with
clean warm water and wiped dry with a soft cloth.
Replace all the shelves and accessories and place
the food back in the refrigerator chamber.
Plug mains lead into wall socket.
Close both appliance doors.
Set the temperature control dial to “9” until it reach-
es an adequate temperature
(how long?)
Replace drawers with frozen food in the freezer
chamber.
Set the temperature control dial to normal use posi-
tion.
Stop the appliance compressor by setting the tem-
perature control dial to “0”
Unplug the mains lead from the wall socket.
Using a philip’s head screw driver, unscrew the bulb
cover
(See Fig.)
Replace the bulb with a new one (220-240 V max.
15W, E14 thread. Maximum bulb dimension: diam-
eter 26mm, length 55mm).
Replace the bulb cover
(See Fig.)
Plug mains lead into wall socket
Set the temperature control dial to normal use posi-
tion.
DOOR SEALS
AFTER CLEANING
REPLACING THE LIGHT BULB