Worth Data 5202D - Manual (Page 55)

Imager Settings:
Illumination Mode
disable LED illumination
,D3A,
enable LED illumination default
,D39,
LED illumination alternating
,D3B,
Aiming On/Off
disable laser aiming and LED illumination
,D3C,
enable laser aiming default
,D3D,
disable laser aiming
,D3E,
Central Reading
enable central reading
(read only a code that the laser aims at) ,D00,
disable central reading
(read the entire image)
default
,D0Z,
1D Code
Decode Mode
careful mode (good for hard to read codes)
,DM3,
standard mode default
,DM2,
semi-quick mode
,DM1,
quick mode (good for easy to read codes)
,DM0,
LCD Display
Scanning
disable scanning from LCD display default
,D3I,
enable scanning from LCD display
,D3J,
Auto Focus
Mode
AF system = laser and contrast default
,E8K,
AF system = contrast only
,E8L,
AF system = laser only
,E8M,
Note: Normally laser ranging is used for reading labels. In case it cannot be used in a brightly-lit
environment, the contrast method is used. When “contrast only” is configured, the reading speed will
be slower.
Fixed Focus
Mode
short range = 90mm
,E8N,
medium range = 163mm
,E8O,
long range = 880mm
,E8P,
A-49