Western Digital T13/2132-D - Manual (Page 15)

June 23, 2010 T13/2132-D Revision 3
Working Draft Enhanced Disk Drive - 4 (EDD-4) 3
2 Normative references
2.1 General
The standards list in 2.2, 2.3, and 2.4 contain provisions that, through reference in the text, constitute provisions
of this standard. At the time of publication, the editions indicated were valid. All standards are subject to
revision, and parties to agreements based on this standard are encouraged to investigate the possibility of
applying the most recent editions of the standards listed in 2.2, 2.3, and 2.4.
Copies of these standards may be obtained from ANSI: Approved ANSI standards, approved and draft
international and regional standards (ISO, IEC, CEN/CENELEC, ITUT), and approved and draft foreign
standards (including BSI, JIS, and DIN). For further information, contact ANSI Customer Service Department at
212-642-4900 (phone), 212-302-1286 (fax), or via the World Wide Web at http://www.ansi.org.
Additional availability contact information is provided as needed.
2.2 Approved references
Copies of the following documents may be obtained from ANSI, an ISO member organization:
a) Approved ANSI standards;
b) approved international and regional standards (ISO and IEC); and
c) approved foreign standards (including JIS and DIN).
For further information, contact the ANSI Customer Service Department:
Phone +1 212-642-4900
Fax: +1 212-302-1286
Web: http://www.ansi.org
E-mail: [email protected]
or the InterNational Committee for Information Technology Standards (INCITS):
Phone +1 202-626-5738
Web: http://www.incits.org
E-mail: [email protected]
Table 1 lists approved ANSI standards, approved international and regional standards (ISO, IEC,
CEN/CENELEC, ITUT). Additional information may be available at http://www.t10.org and http://www.t13h.org.
Table 1 — Approved ANSI References
Name Reference
Volume and File Structure of CD-ROM For Information Interchange ISO 9660-1988
Fibre Channel Framing and Signaling Interface - 2 (FC-FS-2) INCITS 424-2007
(FC-LS) INCITS 433-2006
AT Attachment 8 - ATA/ATAPI Command Set - 8 (ATA8-ACS) INCITS 452-2009
Serial Attached SCSI - 1.1 (SAS-1.1) INCITS 417-2006
Serial Bus Protocol - 2 (SBP-2) INCITS 325-1998
Reduced Block Commands (RBC) INCITS 330-2003
SCSI Primary Commands - 3 (SPC-3) INCITS 408-2005
Multi-Media Commands - 5 (MMC-5) INCITS 430-2007
BIOS Enhanced Disk Drive Services - 3 (EDD-3) INCITS 407-2005
Extended Unique Identifier, 64-bit (EUI-64) ANSI/IEEE 394:1995
IEEE Standard for a High Performance Serial Bus IEEE 1394-2008