Wenger TerraGraph - Manual (Page 4)

Butterfly Clasp
This clasp assures a secure fit of your watch and easy opening and closing.
It allows for a one-time strap fitting instead of refitting each time the watch is
worn. We suggest sighted assistance for this initial fitting.
1. Remove the strap end from the leather loop(s).
2. Open the clasp by gently pulling the end of the strap away from the watch.
In case the strap end is accidentally removed from the metal buckle, place it
back into the buckle with the cross (which is slightly raised) facing outward.
3. Fitting the watch may take some trial and error. Start by identifying the small
pin that's attached to the back of the buckle. Insert the pin into a hole in the
strap. For thicker wrists use the holes closer to the end of the strap or, for
thinner wrists, closer to the watch.
4. Pull the buckle toward the end of the strap to secure the pin.
5. Slip your wrist thru the strap and fold the metal hinge properly so it conforms
to your wrist.
(continued next page)
5 4
Setting the Time
1. Pull out the crown to Position 2
(all the way out). Rotate crown
counterclockwise to set the
hands to the correct time.
2. Return the crown to the fully
depressed Position 1.
Additional Features
Flip-open Crystal
This feature enables you to open the crystal in order to touch-read the time.
1. Press the flip-open pusher, located on the outside of the watch at the
4 o’clock position. The crystal will spring open.
2. Touch the hands and dial to to determine the time.
3. Return the crystal to its fully closed position manually.
Position 1 Position 2