Weider Pro 260 831.15609.0 - Manual (Page 15)

M6 Washer (48)
M10 Nylon Locknut (43)
M
1
0
x
1
6
8
m
m
B
o
lt
(5
0
)
M4 x 16mm Screw (45)
M8 Washer (56)
M10 x 75mm Bolt (42)
M10 x 81mm Bolt (41)
M10 x 65mm Bolt (40)
M8 Nylon Locknut (55)
M8 x 58mm Bolt (52)
M6 x 16mm Screw (39)
M10 x 68mm Bolt (54)
M6 Nylon Locknut (51)
M6 x 40mm Bolt (49)
M10 x 60mm Bolt (47)
M10 x 19mm Bolt (53)
M10 Washer (44)
PART IDENTIFICATION CHART
Refer to the drawings below to identify small parts used in assembly. The number in parentheses by each draw-
ing is the key number of the part, from the PART LIST in the center of this manual.
Note: Some small parts
may have been pre-attached. If a part is not in the parts bag, check to see if it has been pre-attached.