Weider 9940 - Manual (Page 18)

18
43. Wrap the Press Cable (72) around a 3 1/2” Pulley
(24) in the direction shown. Attach the Pulley and a
Cable Trap (25) to the indicated hole
on the far side
of the Leg Press Lever (83) with a 3/8” x 4 3/4” Bolt
(60) and a 3/8” Nylon Jamnut (63).
Note: Thread the
Jamnut only two turns onto the Bolt; you will later
attach another Pulley to the Bolt. Make sure the
Cable Trap is oriented as shown.
43
63
60
25
24
72
83
44. Wrap the Press Cable (72) around a “V”-Pulley (27)
in the direction shown. Attach the “V”-Pulley and a
Large Cable Trap (32) underneath the Press Seat
Frame (7) with a 3/8” x 4 1/4” Bolt (85), a 3/8” Flat
Washer (48), and a 3/8” Nylon Locknut (50).
Note:
the Press Seat Frame has five adjustment holes.
Mount the “V”-Pulley in the hole closest to the
Leg Press Lever. Make sure the Cable Trap is ori-
ented as shown.
44
48
32
85
27
50
72
7
45. Wrap the Press Cable (72) around a 3 1/2” Pulley
(24) in the direction shown. Attach the Pulley and a
Cable Trap (25) to the
near side of the Leg Press
Lever (83). Use the 3/8” x 4 3/4” Bolt (60) that was
inserted in step 43 and secure the Pulley with the
3/8” Nylon Jamnut (63).
Make sure the Cable Trap
is oriented as shown.
45
72
8
63
83
25
60
24
46. Wrap the Press Cable (72) around a 3 1/2” Pulley
(24) in the direction shown. Attach the Pulley and a
Cable Trap (25) to
near side of the Press Upright (2).
Use the 3/8” x 4 3/4” Bolt (60) that was inserted in
step 42 and secure the Pulley with the 3/8” Nylon
Jamnut (63).
Make sure the Cable Trap is oriented
as shown.
Wrap the Press Cable (72) around a 3 1/2” Pulley
(24) in the direction shown. Attach the Pulley and a
Cable Trap (25) to the 3/8” x 4” Carriage Bolt (102)
that was inserted into the Press Base (6) earlier.
Secure the Pulley with the 3/8” Nylon Locknut (50).
Make sure the Cable Trap is oriented as shown.
46
24
25
50
25
63
102
60
2
24
72