A. - off b. - low c. - med. d. - high, Operating instructions, Troubleshooting – weber Electric Grill Q 140 User Manual

Page 10

Advertising
background image

10

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS

3).

5).

2).

4).

D

B

C

A

6).

1).

This appliance is Rated for

120 volts - 50/60Hz, 13 Amps

Output: 1560W

4)

Plug in power cord into a protected outlet.

ƽ The appliance should be supplied

through a grounded GFI outlet, 15
amp minimum.

5)

Preheat the grill. Turn control knob to HIGH
(clockwise). The red light indicates that power is
on and the heating element is heating up.

6)

Close lid. Preheat time will take approximately
15 minutes (when grilling in a 72˚F air
temperature). Colder temperatures and/or wind
can cause longer preheating times.

To cook at a lower grill temperature: Preheat
as previously stated. Turn the control knob
counterclockwise to desired setting. Start cooking.
Reference the cooking charts at end of Owner’s Guide
for approximate grilling times and settings for the cuts
of meats listed. (adjust for conditions).

ƽ WARNING: When red light is off,

heating element may still be hot.

TROUBLESHOOTING

Problem

Check

Cure

Electric grill does not turn on.

Is the Temperature Controller properly inserted into
housing?

Remove and reinstall Temperature Controller.

ƽ Always plug Temperature Controller fully
into grill before plugging power cord into
outlet. (See page 7, Step C)

Is red power light on and temperature control knob fully
turned clockwise to HIGH?

Remove and reinstall Temperature Controller.

ƽ Always plug Temperature Controller fully
into grill before plugging power cord into
outlet. (See page 7, Step C)

Is power available from outlet?

Check electrical service.
Check if GFI is tripped.

If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your
region using the contact information on our web site. Log onto www.weber.com

®

.

COOKING

ƽ WARNING: Completely unwind power

cord. Keep cord clear of cookbox.

1)

Plug Temperature Controller into grill.

ƽ Always plug Temperature Controller

fully into grill before plugging power
cord into outlet. (See page 7, Step C)

2) Open

Lid.

3)

Make sure the Temperature Controller is turned
OFF. (Turn control knob counterclockwise to
ensure that it is in the OFF position.)

A. - OFF

B. - LOW

C. - MED.

D. - HIGH

Advertising