Weider WESY38730 - Manual (Page 9)

9
13. Attach the two 10-pound Short Caps (20) to the
10-pound Center Resistance Bar (44) with two
M4 x 12mm Flat Head Screws (85).
Using ten M4 x 12mm Flat Head Screws (85),
attach the two 10-pound Caps (32) to the 10-
pound Removable Resistance Bar (67), the two
20-pound Caps (77) to the 20-pound Removable
Resistance Bar (36), the four 80-pound Caps (33)
to the two 80-pound Resistance Bars (55), and
the two 40-pound Caps (79) to the 40-pound
Resistance Bar (52).
79
77
32
20
33
67
36
55
52
85
85
85
85
85
44
13
12
12. Insert the rod on the Backrest Frame (15) into the
slot in the Seat Carriage (12). Hold the Backrest
Frame vertically over the Seat Carriage and
slide the rod into the slot, as shown in the
inset drawing.
15
12
Rod
Slot
12
15
14
86
72
Rings on
this side
Edges
up
52
55
55
44
36
67
18
Rods
35
18
4
14. Locate the Fulcrum (18) on the Top Upright (4)
(see the inset drawing). Slide the Tray (35) onto
the rods on the Fulcrum. Make sure the Tray is
oriented as shown in the drawing.
Set the Resistance Bars into the Tray (35) in the
following order: the 10-pound Removable
Resistance Bar (67), the 20-pound Removable
Resistance Bar (36), an 80-pound Resistance Bar
(55), the 10-pound Center Resistance Bar (44),
the other 80-pound Resistance Bar (55), and the
40-pound Resistance Bar (52). Make sure the
indicated rings are on the side shown and the
arrows point toward the Tray.
Attach the Cover Plate (72), with the edges up, to
the Tray (35) with two M8 x 19mm Button Head
Screws (86).