World Marketing of America KOZY-WORLD KWN121 - Manual (Page 7)

7
INSTALLATION
Figure 6 - Removing Lower Front
Panel Of Heater
Figure 4 -Mounting Clearances As
Viewed From Front Of Heater
WARNING: Maintain the
minim um clearances sho wn
in F ig u r e 4 . If yo u c a n ,
provide greater clearances from
floor, ceiling, and joining wall.
FASTENING HEATER TO WALL
Mounting Bracket
The mounting bracket is located
on back panel of heater (see
Figure 5). It has been taped there
fo r sh ip ping . Remo ve m ou ntin g
bracket from back panel.
Removing Lower Front Panel Of
Heater
1. Remove two screws near
bottom corners of lower front
panel.
2. Pull bottom of lower front panel
forward, then down (see Figure
6).
Methods For Attaching Mounting
Bracket To Wall
Only use last hole on each end
of mounting bracket to attach
bracket to wall. Attach mounting
bracket to wall only in one of two ways:
1. Attaching to wall stud
2. Attaching to wall anchor
Attaching to Wall Stud: This method
provides the strongest hold. Insert
mounting screws through mounting
brack et an d into w all stud s.
Attaching to Wall Anchor: This
m etho d allow s you to attac h
mounting bracket to hollow walls
(wall areas between studs) or to
solid walls (concrete or masonry).
Decide which method better
suits your needs. Either method
will provide a secure hold for the
mounting bracket.
Marking Screw Locations
1. Tape mounting bracket to wall
where heater will be located.
Make sure mounting bracket is
level.
2. Mark sc rew loc atio ns on
wall. (see Figure 7)
Note: Only mark last hole on
each end of mounting bracket.
Insert mounting screws through
these holes only.
3. Remove tape and mounting
bracket from wall.
Figure 7 - Mounting Bracket
Clearances
WARNING: Maintain
minimum clearances shown in
Figure 8. If you can, provide
greater clearances from floor
and joining wall.
Figure 5 -Mounting Bracket
Location