Weider WEBE27320 - Manual (Page 11)

11
17. Press a 51mm x 76mm Inner Cap (21) into the
top of a Front Upright (44). Attach an Upright
Cover (51) to the Front Upright with five M4 x
16mm Screws (63).
Attach the Front Upright (44) to a Base (42) with
four M10 x 94mm Bolts (18), two Small Joint
Plates (40), and four M10 Nylon Locknuts (32).
Do not tighten the Locknuts yet.
Repeat this step with the other Front Upright
(44) and the other Base (42).
18. Attach the Left Rear Upright (46) to the left Front
Upright (44) with four M10 x 94mm Bolts (18),
two Small Joint Plates (40), and four M10 Nylon
Locknuts (32). Do not tighten the Locknuts yet.
Repeat this step with the Right Rear Upright (not
shown).
19. Press two 51mm Round Inner Caps (23) into the
ends of the two Carriage Tubes (69). Screw the
Carriage Tubes onto the Weight Carriage (50) as
shown. Make sure the Carriage Tubes are fully
tightened.
17
18
19
21
51
44
63
63
63
63
63
40
32
32
42
32
40
44
40
46
23
23
69
69
50
18
18
18
40