weber Grill - Manual (Page 14)

14
Figure 8
Step 8
Add bowl panel, tool holders and CharBin
Storage Container
You will need: bowl panel, three tool holders and
CharBin Storage Container.
Remove protective plastic covering from bowl
panel. Slide the ends of bowl panel under bowl
mounting brackets so the ends rest on tabs inside
frame. Set the panel in place on top of the frame brace.
Figure 8.
Hook the tool holders over the frame rail. There is a cut
out on the right side of the front panel to accommodate
the tool holders. Figure 8.
Tool holders
CharBin
Bowl panel
Tab
(a)
(b)
Figure 9
Note: Before sliding the CharBin into place check that
the Cooking grate holder is sitting loosely on the frame
brace and is conforming to the frame brace.
Figure 9 (a). If it is tight or stuck over the edge of the
frame brace, Figure 9 (b), reposition as in Figure 9 (a).
If the Cooking grate holder is not correctly positioned, it
could allow the CharBin to slide through the frame.
Slide CharBin down into the top frame with the deep
end toward the rear. Figure 9.
CharBin
Inside of
Frame Brace
Cooking grate
holder