Important hearing care information, Insertion and removal instructions, Caring for your cr-1 earphones – Westone Laboratories CR-1 User Manual

Page 2

Advertising
background image

Important Hearing Care Information

If, after using your Westone CR-1 Earphones, everything sounds
muffled, or if you hear ringing or buzzing, your ears are trying
to give you a warning! These symptoms are normally associated
with a condition known as Temporary Threshold Shift and are an
indication of conditions that could lead to permanent hearing
loss.

While no two individuals’ hearing sensitivity is exactly the
same, there are established safety guidelines for sound levels
versus time of exposure. The following chart is based on OSHA’s
(Occupational Health and Safety Administration) exposure
information for industry. Remember that these guidelines are
based on average hearing sensitivity, your sensitivity may be above or below these levels.

The use of any earphone offers benefits and risks. Westone CR-1 Earphones can
lower ambient sound levels approximately 25dB when properly worn. However, the
performance capabilities of the earphones can allow the user to negate the benefits of
hearing protection from ambient sound. We want you listening for a lifetime!

Remember, personal hearing protection is your responsibility!

Insertion and Removal Instructions

Identify the left and right CR-1 earphones. The red dot
indicates the right earphone while the blue is for the left.
With your right hand, hold the right earphone so that the
cable points toward the back of your head. Use your left
hand to pull up the outer ear while inserting the canal
tip of the earphone into your ear canal. Slowly rotate the
earphone counter clockwise into place.

A light coating of Westone Oto-Ease

®

on the canal tip of

the earphone will ease insertion. The earphone should
almost seem to snap into place. Insert the left earphone in
the same manner, but rotate it clockwise into place.

Reverse these steps to remove the CR-1’s. For the right ear,
pull back on the outer ear with your left hand to break
the seal, then turn the earphone clockwise to remove it.
Rotate counter clockwise for your left ear.

Caring for your CR-1 Earphones

Here are a few simple guidelines that can greatly increase your listening enjoyment
and lifespan of your Westone CR-1 earphones.

· Always store your earphones in the provided case.

· In case of poor sound quality due to earwax in the sound bore, use the included wax

removal loop to carefully remove the earwax. Never use any other object to attempt
to remove the earwax as this may result in damage to the earphone and will void the
warranty.

· Do not use the cord to remove the earphones from your ears. This may cause damage

to the cord and result in poor performance. Damage of this nature is not covered by
the warranty.

· Do not expose your earphones to temperature extremes. Avoid strong impacts to

your earphones.

· Wipe down earphones after each use and never immerse them in water.

Right ear shown

Please Note

These CR-1 earphones were made specifically to fit your ears. Their performance
depends on a snug fit and firm acoustic seal. Please be advised that any significant
change in your weight (gain or loss) can result in changes to the shape and/or size of
your ears and ear canals. This will affect the performance of your CR-1s, not only in
sound quality, but also in the amount of hearing protection afforded.

If you experience this type of problem, see your hearing care provider or dealer to
have new impressions taken. Your earphones can then be re-manufactured from the
existing components to address the fit issue. Charges will apply.

Moisture in your earphones can cause temporary performance issues. Do not insert
your earphones if your ears are wet. Always dry your ears completely before inserting
your earphones. Should you inadvertently allow water or perspiration into the
earphones and they quit working, allow to dry completely before attempting to use
again. Minor moisture build-up should dry out and not affect long-term performance.
Extended exposure to moisture or submersion will result in permanent damage (not
covered by the warranty).

Maximum

dB level exposure time

85

8 hr.

90

4 hr.

95

2 hr.

100

1 hr.

105

30 min.

110

15 min.

115

7.5 min.

Advertising