Weider WESY85070 - Manual (Page 10)

10
16. Remove the 3/8Ó x 1 3/4Ó Bolt (48), 3/8Ó Nylon Jam
Nut (5), and 3 1/2Ó Pulley (15) from the indicated
bracket on the Top Frame (67). Insert the end of the
Long Cable (66) through the bracket and down
through the indicated hole.
Re-attach the 3 1/2Ó Pulley (15) to the bracket on
the Top Frame (67) with the 3/8Ó x 1 3/4Ó Bolt (48)
and 3/8Ó Nylon Jam Nut (5). Be sure that the Long
Cable is between the Pulley and the top of the
bracket.
17. Wrap the Long Cable (66) around the ÒVÓ Pulley
(76). Attach the Pulley and a Large Cable Trap (82)
to the welded bracket on the Top Frame (67) with a
3/8Ó x 2 1/4Ó Bolt (50) and 3/8Ó Nylon Jam Nut (5).
Be sure that the Large Cable Trap is turned to
the indicated position.
18. Note: The 3 1/2Ó Pulley (15) used in this step is
pre-assembled. It is shown removed for easier
part identification.
Route the Long Cable (66) around the 3 1/2Ó Pulley
(15) on the left Arm (46). Tighten the 3/8Ó Nylon
Jam Nut (5) and 3/8Ó x 1 3/4Ó Bolt (48). Be sure
that the Cable Trap (59) is oriented as shown.
16
17
18
66
15
48
59
5
66
50 82
76
5
67
66
67
48
Hole
5
15
46