Weider 831.153933 - Manual (Page 14)

14
29. Wrap the Lat Cable (88) around a 3 1/2” Pulley
(78). Attach the Pulley and a Long Cable Trap (102)
to the Top Frame (6) with a 3/8” x 1 3/4” Bolt (93)
and a 3/8” Nylon Jamnut (113). Make sure the
Cable Trap is turned to hold the Cable in the
groove of the Pulley.
33. Wrap the Butterfly Cable (69) over a “V”-pulley (55).
Attach the Pulley and a Long Cable Trap (102) to
the indicated bracket on the Butterfly Upright (3)
with a 3/8” x 2 1/2” Bolt (18) and a 3/8” Nylon
Locknut (87). Make sure that the Long Cable
Trap is turned to hold the Cable in the groove of
the Pulley.
30. Remove the preattached 3 1/2” Pulleys (78) from
the Pulley Plates (63).
Wrap the Lat Cable (88) around a 3 1/2” Pulley
(78). Attach the Pulley and a Cable Trap (68) to the
second set of holes from the top of the Pulley
Plates (63) with a 3/8” x 2” Bolt (100) and a 3/8”
Nylon Locknut (87). Make sure the Cable Trap is
turned to hold the Cable in the groove of the
Pulley.
31. Attach the end of the Lat Cable (88) inside of the
Butterfly Top Frame (7) with a 5/16” x 2 1/2” Bolt
(59), two 5/16” Washers (90), and a 5/16” Nylon
Locknut (86).
29
30
31
32
33
63
86
90
90
59
88
113
102
78
87
88
100
88
78
93
6
103
7
70
69
25
69
3
87
55
102
18
32. Locate the Butterfly Cable (69), which is the
shortest Cable. Attach the Cable to the Pivot
Bracket (70) on the Left Butterfly Arm (25) with a
5/16” x 1” Shoulder Bolt (103) and a 5/16” Nylon
Locknut (86).
86
68