Winegard SD - Manual (Page 2)

2
1 . Open box and remove packing material.
2. Lift dome out of box vertically. Then lift unit out of
box vertically. Do not turn box and “roll” out, or turn
upside down to remove.
4’ Gray Coax Cable (OEM Model)
4’ White Coax Cable (OEM Model)
4’ Power Cable (OEM Model)
!
Parts Included • Tools Needed • How to Unpack
If using knife to open
carton, BE CAREFUL.
Do not cut the dome on
the unit.
1 Radome
1 Cable entry plate
All required screws, washers, bolts, and nylocks
1 base with electronics, dish, dual LNBF,
mounting feet
LIFT UNIT STRAIGHT UP
OUT OF CARTON!
UNPACKING THE UNIT
PARTS INCLUDED:
The Winegard RoadTrip is designed specifically for use with motorized recreational
vehicles. Winegard recommends using a qualified installer familiar with RV structure and
wiring to ensure proper installation and to prevent damage to RV or dish.
REV. 12/05
USE 2 PEOPLE
when removing the unit
from the carton.
!
DO NOT PAINT DOME!
Painting dome will
cause signal
degradation and will
void your warranty.
TOOLS NEEDED FOR UNPACKING & INSTALLATION:
Level
Drill w/3/4” bit
1-1/4” hole saw (if mounting switch in wall)
Phillips screw driver #2 3/8” Open end wrench
7/16” Open end wrench
Sealant (consult RV manufacturer for proper type
for your roof material)