Weider WESY19740 - Manual (Page 9)

9
8. Attach the Shroud (17) to the Top Frame (4) with
two M6 x 16mm Screws (62) and two M6
Washers (82).
Attach the Shroud (17) to the brackets on the
Stabilizer (2) with two M6 x 16mm Screws (62)
and two M6 Washers (82).
Make sure the brack-
ets are inside the Shroud.
Tighten the Nylon Locknuts (56, 58) used in
steps 2–7.
9. Grease the M10 x 77mm Bolt (79). Orient the Leg
Lever (8) with the welded support as shown.
Attach the Leg Lever to the Front Leg (7) with the
Bolt and an M10 Nylon Locknut (56).
Do not
overtighten the Locknut; the Leg Lever must
be able to pivot easily.
10. Grease the M10 x 77mm Bolt (79). Attach the
Pivot Frame (5) to the Top Frame (4) with the Bolt
and an M10 Nylon Locknut (56).
Do not over-
tighten the Locknut; the Pivot Frame must be
able to pivot easily.
Attach the two Arm Pins (40) to the Pivot Frame
(5) with two M4 x 20mm Self-tapping Screws
(69). Insert the Arm Pins into the two holes in the
Upright (3).
8
9
10
62
62 82
82
17
4
62
62
82
82
Bracket
2
56
79
Grease
Welded
Support
7
8
Grease
Holes
5
56 79
69
69
3
40
40
4
Arm Assembly