Western Telematic CAS-161A - Manual (Page 12)

3.1.2.2. Parity (Sw8)
Parity can be set to Even, Mark, Odd, None, or Space.
Parity
Switch 8 (Bank 2)
1 (On) 0 (Off)
Even, Mark X
Odd, None, Space X
3.2. Connect Power Cable
1. Make certain the power switch is in the OFF position.
2. Attach one end of the power cable to the AC power
connector on the CAS-161A. Attach the other end to a
grounded wall outlet.
3.3. Connect Data Cables
Note: Check to make certain all data cables are
compatible. Refer to the Appendix for a description
of the interface.
1. Make certain the power switch is OFF.
2. Connect the data cables from the devices to be controlled
to the ports labeled 1 - 16 on the master unit.
If your installation includes optional CAS-161A Add-On
Modules, install the additional Modules as described in
Appendix C, and then connect ports 17 - 64.
3. Connect the cable from your control device (PC, modem,
etc.) to the MODEM connector on the CAS-161A.
3-4
CAS-161A User’s Guide