Weider Pro 290 W 30664.0 - Manual (Page 9)

9
10. Attach the Curl Pad (45) to the Curl Post (27) with
two M6 x 16mm Screws (29).
10
45
27
29
11
19
48
14
12
33
12. Insert the Inner Bar (43) into the Outer Bar (40)
and align the indicated holes. Using a hammer,
tap the two Roll Pins (41) into the holes until they
are flush with the Outer Bar.
12
43
40
41
41
Holes
Holes
11. Insert an M10 x 19mm Bolt (48) into the bracket
on the Weight Carriage (12) from the side shown.
Slide the Weight Carriage (12) onto the Lat Tower
(14). Make sure that the bracket on the Weight
Carriage and the lat bar rest on the Lat Tower
are on opposite sides of the Lat Tower. Attach
the Cable (19) to the M10 x 19mm Bolt (48) with
an M10 Locknut (33).
Bracket
Lat Bar
Rest
13. Make sure that all parts are properly tightened before the weight bench is used. Note: Some hardware
may be left over after assembly is completed. The use of all remaining parts will be explained in ADJUST-
MENT, starting on page 10.