weber 42377 - Manual (Page 5)

5
MOUNTING THE
SIDE BURNER
Connect the corrugated gas line to the side burner valve
located on the back right hand side of side burner.
Test connections
All connections and joints must be thoroughly
tested for leaks in accordance with local codes
and all listed procedures in the latest edition of
ANSI Z223.1/NFPA 54.
ƽ DANGER
Do not use an open fl ame to check for gas leaks.
Be sure there are no sparks or open fl ames in
the area while you check for gas leaks. This will
result in a fi re or explosion which can cause
serious bodily injury or death, and damage to
property.
Be sure to secure the side burner unit with non corrosive
screws anchored into the fi nished surface of the “island
structure”.
Replace the plastic plug on the front mounting hole to
conceal the screw once side burner is secure.
to regulated
gas supply
3/8" SAE stainless
corregated gas line
GAS INSTRUCTIONS
BUILT-IN GAS LINE LOCATIONS
GENERAL CONSTRUCTION DETAILS
• Summit
® Built-In side burner unit should be on site
before construction begins.
• All dimensions have a tolerance of plus or minus
+/-
1/4 ” inch.
Provide access for a corrugated gas line depending on
the location of the side burner in relation to your main gas
supply and regulator position.
Area should be kept clear of sharp, jagged, or
extremely abrasive surfaces to avoid possible damage
to gas supply lines. Exercise caution when pulling gas
lines through built-in structure.
A 3/8 “ inch stainless steel corrugated gas line should be
used to connect the side burner to the regulator accessory
coupling.
ƽWARNING: Do not use a rubber gas hose.