Winegard RD-4600 - Manual (Page 5)

5
FIGURE 4
Rotation
Clamp
ASSEMBLED VIEW
CAUTION: THE
ANTENNA
MUST BE IN
THE TRAVEL POSITION
BEFORE ALIGNING THE
DIRECTIONAL HANDLE,
AND CEILING PLATE.
Tighten screw snugly
POINT TO
FRONT OF RV
POINTER
MUST POINT
TO CENTER
OF ROTA-
TION CLAMP
WHEN IN
TRAVEL
POSITION
1 Ceiling Plate
3 Directional
Handle Extension
4 Directional
Handle
ALIGN
POINTER WITH
ANTENNA
TRAVEL
POSITION
2 (4) #10 Phillips Flat
Head Screws
FIGURE 8
5 ELEVATING
CRANK HANDLE
(When installed,
extends 2-1/4"
from ceiling).
Snap Handle
into base
when not in use.
CAUTION: After INITIAL
INSTALLATION,
the antenna SHOULD ROTATE
APPROXIMATELY 360
DEGREES FROM TRAVEL
POSITION.
The pointer on the
DIRECTIONAL HANDLE
should point towards the
ROTATION CLAMP when in
TRAVEL POSITION.
POINT TO POINT TO POINT TO POINT TO POINT TO
FRONT OF RV
FRONT OF RV FRONT OF RV FRONT OF RV FRONT OF RV