Weider PRO 900 - Manual (Page 10)

10
15. Secure the looped end of the Cable (34) to the
M19 x 19mm Bolt (46) in the bracket on the
Weight Carriage (32) with an M10 Nylon Locknut
(19).
Next, slide the Carriage Stop (39) onto the Lat
Tower (26). Secure the Carriage Stop with an M8
x 70mm Bolt (54) and an M8 Nylon Locknut (13).
Note: The Carriage Stop must be positioned with
the lip on top as shown.
16. Insert the Lat Tower (26) into the Lat Tower Base
(35). Make sure that the Lat Tower is turned as
shown. Secure the Lat Tower with two M10 x
65mm Bolts (18), four M10 Washers (24), and
two M10 Nylon Locknuts (19).
17. Attach the Lat Bar (36) to the Cable Clip (33) and
place the Lat Bar in the lat bar rest on the Lat
Tower (26).
18. Make sure that all parts are properly tightened
before you use the weight bench. The use of
all remaining parts will be explained in USING
THE WEIGHT BENCH on pages 11 and 12.
26
34
19
32
46
13
54
39 Lip
15
16
26
19
24
18
35
17
36
Lat Bar Rest
26
33