Whirlpool GR450LXL - Manual (Page 18)

18
To Replace:
1. Hold oven door by the handle and place the top of the door
under the cooktop overhang.
2. Use front of leg to apply pressure to slide hinges into the slots
as far as possible.
3. Use side of leg to apply pressure to the bottom of the door
front.
4. Lift door slightly. Apply pressure and push until the hinges
have gone in fully.
5. Fully open the door.
6. Tighten clips with a #2 square or Phillips screwdriver.
Storage Drawer
The storage drawer can be removed. Before removing, make sure
drawer is cool and empty.
To Remove:
1. Pull drawer straight out to the first stop.
2. Lift up the back of the drawer and pull out.
To Replace:
1. Fit the ends of the drawer rails into the guides in the cavity.
2. Slide the drawer closed.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of
an unnecessary service call.
Nothing will operate
■ Is the power supply cord unplugged? Plug into a grounded
outlet.
■ Has a household fuse blown or has the circuit breaker
been tripped? Replace the fuse or reset the circuit.
Cooktop will not operate
■ Is the control knob set correctly? Push in knob before
turning to a setting.
■ On ceramic glass models, is the “Cooktop Lockout” set?
See “Cooktop Lockout” section.
Right front surface cooking area will not operate
■ Cannot boil on right front surface cooking area? Press the
ACCUSIMMER™ switch to OFF. Turn right front control knob
to HI for a rapid boil.
■ ACCUSIMMER will not simmer? Turn right front control
knob on between the ACCUSIMMER LO and 4 settings, while
pressing the ACCUSIMMER switch on.
■ ACCUSIMMER surface cooking area does not get hot
enough? Turn right front control knob to 4 while pressing the
ACCUSIMMER switch on.
Excessive heat around cookware on cooktop
■ Is the cookware the proper size? Use cookware about the
same size as the surface cooking area, element or surface
burner. Cookware should not extend more than 1 in. (2.5 cm)
outside the cooking area.
Hot Surface Indicator Light Stays On
■ Does the Hot Surface Indicator Light Stay on after control
knob(s) have been turned off? See “Cooktop Controls”
section.
Cooktop cooking results not what expected
■ Is the proper cookware being used? See “Cookware”
section.
■ Is the control knob set to the proper heat level? See
“Cooktop Controls” section.
■ Is the appliance level? Level the appliance. See the
Installation Instructions.
Oven will not operate
■ Is the electronic oven control set correctly? See
“Electronic Oven Control” section.
■ Has a delay start been set? See “Timed Cooking” section.
■ On some models, is the Control Lock set? See “Control
Lock” section.