Weider WEBE37340 - Manual (Page 17)

15
27. Locate the Long Cable (68). Route the eyelet
end of the Cable through the Foot Plate (67) and
the Center Upright (45), and under a Pulley (87).
Attach the Pulley (87) inside the Center Upright
(45) with an M10 x 75mm Bolt (92), two M10
Washers (35), two 17mm Spacers (89), and an
M10 Nylon Locknut (34). Note: The Foot Plate
(67) is shown pulled away from the Center
Upright for clarity.
31. Attach the Long Cable (68) inside the Weight
Guide Base (41) with an M10 x 75mm Bolt (92),
two M10 Washers (35), two 28mm Spacers (91),
and an M10 Nylon Locknut (34).
30. Wrap the Long Cable (68) over a Pulley (87).
Attach the Pulley and a Cable Trap (88) to the
second set of holes from the bottom of the Pulley
Plates (82) with an M10 x 45mm Bolt (33) and an
M10 Nylon Locknut (34). Make sure the Cable
Trap is oriented to hold the Cable in the
groove of the Pulley.
28. Wrap the Long Cable (68) over a Pulley (87).
Attach the Pulley to the Double “U”-bracket (81)
with an M10 x 45mm Bolt (33) and an M10 Nylon
Locknut (34).
29. Wrap the Long Cable (68) under a Pulley (87).
Attach the Pulley to the Weight Guide Base (41)
with an M10 x 45mm Bolt (33) and an M10 Nylon
Locknut (34).
27
28
67
68
45
34
35
35
87
89
87
68
34
81
33
29
30
31
68
87
34
33
41
82
33
34
34
35
91
91
88
68
87
68
41
92
35
92
89