Whistler XTR-130 - Manual (Page 6)

VG-2 Detection Mode
The VG-2, also known as a “radar detector
detector,” is a special receiver used by
police to detect signals radiated by a radar
detector. See page 21 for more information
on VG-2.
Press the VG-2 button once. Unit beeps
once for on, twice for off.
When a VG-2 signal is detected the VG-2
alert is sounded. After 3 seconds the audio
is cancelled and the “V” Icon flashes. This
cycle is repeated if the VG-2 signal is again
detected.
During the period a VG-2 signal is detect-
ed, a radar signal cannot be
detected. However, because the VG-2 alert
has confirmed that a patrol car is nearby,
you are already aware of the potential for
speed monitoring and can adjust your
speed accordingly. Laser detection is not
affected while a VG-2 signal is detected.
N No otte e:: VG-2 must be turned on each time
the unit is turned on to receive VG-2 Alerts.
VG-2 ALERTS LASER/RADAR ALERTS
Safety Warning System/Audio/Visual
Alerts When your XTR-130 Whistler detec-
tor detects a safety radar signal, it provides a
distinctive audio tone and illuminates the
first LED and the last LED of the Signal
Strength Indicator.
N No otte e:: You will not be able to receive SWS
alerts if transmitters are not located in your area.
Total Band Protection ™
Complete Band Coverage that detects
laser, radar, VG-2 and safety radar bands.
14 15
TROUBLESHOOTING GUIDE
Your Whistler detector is expertly
engineered and designed to exacting
quality standards to provide you with
reliable, trouble-free operation. If your unit
has been correctly installed following the
guidelines in this manual, but is not
operating optimally, please refer to the
troubleshooting guide below.
PROBLEM: No display or audio.
Check fuse in Whistler plug; replace if
necessary with a 2 amp 3AG type. Check
fuse for lighter socket; replace if necessary.
Make sure lighter socket is clean.
PROBLEM: Audio alerts are not loud
enough. Cancel Auto Quiet Mode or City
Mode. Check audio level setting (see pg.9).
PROBLEM: Unit alarms when vehicle hits
bumps. Check for loose lighter socket; tighten
and clean. Check connections at both ends of
power cord. Substitute another cord to
determine if cord is defective. Return
defective cord to the factory.
If difficulties occur which cannot be solved by
information in this Troubleshooting Guide,
please call Whistler Customer Service at
1-800-531-0004 or visit our FAQ page at
www.whistlergroup.com/faq-detectors.asp
before returning your unit for service.
16
X XT TR R--1 13 30 0 S SW WS S D Diis sp plla ay y
Alert