Wayne-Dalton TORQUEMASTER 5120 - Manual (Page 19)

19
Tools Needed:
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
INST
All
ATION
TorqueMaster ® Spring Tube
TorqueMaster ® springs come lubricated
and pre-assembled inside the
TorqueMaster
® spring tube. To install, lay
the TorqueMaster ® spring tube on the
floor (inside garage) in front of the door
with the labeled end to the left.
laBElED END
TORquEMasTER ®
sPRING TuBE
None
15
16
Center bracket bushing
NOTE: If you are installing the idrive ®
opener on your garage door, skip this
step and continue with step 17.
NOTE: If you are not installing an idrive ®
opener on your garage door, you must
install the center bracket bushing
assembly. Follow these instructions for
non-
idrive ® operated garage doors.
NOTE: If you are installing a
DoorMaster
™ opener, see optional
DoorMaster ™ Bracket installations on
page 31, Figure a.
Being cam shaped the center bracket
bushing only fits one way.
slide the center bracket assembly
towards the center of the TorqueMaster
®
spring tube, from the right side as
shown.
NOTE: upon completion of this step,
continue with step 18.
CENTER
BRaCkET
assEMBly
TORquEMasTER ®
sPRING TuBE
TORquEMasTER ®
sPRING TuBE
CENTER
BRaCkET
BushING
None