Whirlpool 2LSR5233BN0 - Manual (Page 8)

8
What happens in each cycle
When the Cycle Control Knob is set to a
number and pulled out, the washer fills (to the
selected load size) before agitation and timing
start. The washer will begin agitating immedi-
ately after filling; agitation can occur with the
washer lid up or down. After agitation starts,
the Cycle Control Knob turns clockwise until it
points to an OFF area and the cycle ends. NOTE: A Gentle Wash system helps protect
your fabrics by reducing wash agitation
speed during the last few minutes of wash
agitation in the REGULAR and PERMA-
NENT PRESS cycles.
O P E R A T I N G Y O U R W A S H E R
RINSE
Fill
▼
Rinse
▼
Drain-No agitation
▼
Spin-Spray rinse
▼
Spin
▼
Off
WASH
Fill
▼
Wash selected time
▼
Drain (or partial drain † )
No agitation
▼
Spin
▼
† The Permanent Press cycle partially
drains, fills, agitates briefly, and drains.
MAGIC CLEAN* lint filter
The lint filter at the bottom of the washer
basket cleans itself. During agitation, wash
and rinse water pass over the filter, separat-
ing the lint from the water. The lint is then
spun away from the filter and out of the
system during the spin part of the cycle.
If your washer drains into a tub, remove
any lint collected in the tub or strainer.
MAGIC CLEAN
lint filter Basket
interior