Wagner Cordless Power Roller - Manual (Page 3)

Assembling the Roller
Installing the Batteries and Attaching the Strap
1. Open the battery
door. The battery
door is located on
the drive housing.
2. Insert the batteries
in the proper
direction.
Improper installation of batteries may cause batteries to
overheat and leak acid. Acid may cause severe injury and/or
property damage.
3. Attach the strap to the loops on the drive housing.
Removing and Attaching the Drive Housing to
the Fluid Tank
1. Remove the drive housing by
turning the drive housing
counterclockwise.
2. Attach the drive housing by
setting it onto the fluid tank at
a 90° angle and turning
clockwise.
Attaching the Fluid Hose
1. Slide the fluid hose through
the anti-kinking spring and
the spring clip.
2. Push the fluid hose to the
port on the side of the
drive housing.
3. Slide the spring clip over
the fitting to keep the hose
securely in place.
4. Slide the anti-kinking
spring up against spring
clip.
Checking the Inlet Valve
If the unit is new or has been stored for an extended period of time
the inlet ball can become stuck and the pump may be difficult to
prime. To check:
1. Turn the valve body
counterclockwise and pull
down to remove.
2. Shake the inlet valve
assembly gently. If it does
not rattle, remove the inlet
ball retainer and clean the
ball.
3. Reassemble the inlet valve.
Filling the Fluid tank
1. Place the drive housing on the fluid tank at a 90° angle.
2. Remove the fluid tank cap
and fill the tank with paint.
3. Wipe the lip, threads, and
body of the fluid tank to
remove any spilled or
splattered material.
4. Replace the cap and lock the
drive housing securely onto
the fluid tank.
Using the Roller
The On/Off switch has two speeds for
controlling the paint flow – High and
Low. Choose the setting which is
appropriate for your application. If too
much paint is being delivered to the
roller on High speed, use the Low
speed setting. If paint flow is still too
great, shut the roller off, then turn back
on when more paint is needed.
Applying Paint
Begin rolling as paint appears to saturate the roller cover. If paint is
flowing faster than you can roll,turn the pump off until more paint is
needed.
NOTE: Do not place the roller below the level of the paint when
not in use. Paint will siphon to roller even if motor and
pump are turned off.
Inlet Ball
Retainer
Ball
Inlet Ball
Holder
Inlet Valve
Assembly
Fluid Hose
Close
Open
NOTE: Use high quality alkaline batteries only.
CAUTION
+ -
+ - - +
- +
R ©1997 Wagner Spray Tech. All rights reserved. 3 English