Use and care guide, Program summary/selection, Operating instructions – Westland Sales DWV303B User Manual

Page 11

Advertising
background image

9

PROGRAM SUMMARY/SELECTION

PRE-RINSE
Water Temperature:

Incoming Water

(Tank Temperature)

Program Duration:

6 Minutes

Water Consumption:

0.84 gal. (3.2 liters)

NORMAL/SANIWASH
Water Temperature:

154°F / 68°C

Program Duration:

35 Minutes

Water Consumption:

3.3 gal. (12.8 liters)

NORMAL/ECONO
Water Temperature:

Incoming Water

(Tank Temperature)

Program Duration:

35 Minutes

Water Consumption:

3.3 gal. (12.8 liters)

SHORT/SANIWASH
Water Temperature:

154°F / 68°C

Program Duration:

23 Minutes

Water Consumption:

2.5 gal. (9.6 liters)

SHORT/ECONO
Water Temperature:

Incoming Water

(Tank Temperature)

Program Duration:

23 Minutes

Water Consumption:

2.5 gal. (9.6 liters)

NOTE: At the beginning of each cycle, the dishwasher
always starts in the “drain” mode. This is because the
drain pump always retains a small amount of water (in the
sump) from the previous (last) cycle. This is necessary
to keep the pump primed. Therefore, don’t be alarmed
if a small amount of water being pumped out from the
drain hose prior to the start of the regular wash cycle.
THIS IS NORMAL.

To Operate Your Dishwasher

1. Make sure the water inlet and drain hoses are correctly

and securely connected.

2. Push the “Door Open” button to open the door.

3. Place the dishes on the Dish Rack and cutlery (unsorted)

inside the Silverware Basket.

4. Check to make sure that the rotating spray arm can turn

freely all the way around. If necessary, remove any
obstacles.

5. Fill the detergent in the recessed area on the door panel

(approx. 7 grams).

6. Firmly close the door.

7. Open the hot water supply.

8. Turn the Program Selector switch to the desired wash

program. (Pre-Rinse, Normal Wash, or Short Wash).

9. Push the Power On/Off button.

- Push button “in”= Power ON
- Push button “out”= Power OFF. The Power Light will

illuminate, indicating the machine is receiving power.

10. The dishwasher stops automatically at the end of the

program. Both the Power Light and the and the Saniwash
Light will remain illuminated until the Power ON/OFF
button is switched OFF. NOTE: The dishwasher is
designed to stop if the door is opened accidentally
during operation.

11. When the cycle is complete, always relieve pressure on

the inlet hose by following the instructions on page 7.

12. After washing, dishes should be allowed to cool down for

approx. 15 minutes so they are not too hot to handle.
Dishes will cool quicker if door is slightly open.

13. After unloading the dishwasher, remove the Filter, clean

off any bits of food, and put the Filter back in it’s position.

USE AND CARE GUIDE

OPERATING INSTRUCTIONS

vesta_dwv303b.indd Sec1:9

11/9/2005 8:32:30 AM

Advertising