White Outdoor Snow Boss 750T - Manual (Page 14)

14
NOTE: The support bracket must rest on the stop bolt
after the new belt has been assembled.
Figure 16
Servicing Friction Wheel Rubber
The rubber on the friction wheel is subject to wear and
should be checked after 25 hours of operation, and
periodically thereafter. Replace the friction wheel
rubber if any signs of wear or cracking are found.
• Drain the gasoline from the snow thrower.
• Tip the snow thrower up and forward, so that it rests
on the housing.
• Remove six self-tapping screws from the frame
cover underneath the snow thrower.
• Remove the click pins which secure the wheels,
and remove the wheels from the axle.
• Using a 7/8" wrench to hold the shaft, loosen, but
do not completely remove, the hex bolt and bell
washer on the left end of gear shaft. See Figure 17.
Figure 17
• Lightly tap the hex nut to dislodge the ball bearing
from the right side of frame before removing the hex
nut and bell washer from left end of shaft.
• Move the gear shaft to the right and slide the friction
wheel assembly from the shaft. See Figure 18.
• Remove the six screws from the friction wheel
assembly (three from each side). Remove the
friction wheel rubber from between the friction
wheel plates. See Figure 18.
• Reassemble new friction wheel rubber to the
friction wheel plates and hub, tightening the six
screws in rotation and with equal force.
• Position the friction wheel assembly up onto the pin
of the shift rod assembly, and slide the shaft
through the assembly. Reassemble in reverse
order.
Figure 18
Off-season Storage
WARNING: Drain fuel into an approved
container outdoors, away from an open
flame. Allow engine to cool. Extinguish
cigarettes, cigars, pipes, and other
sources of ignition prior to draining fuel.
Fuel left in engine for extended periods
deteriorates and will cause starting
problems.
Drive Plate
Friction
Wheel
Stop Bolt
Support Bracket
Auger Pulley
Track
Hex Bolt &
Bell Washer
Friction Wheel Rubber
Screws
Screws
Friction Wheel Plates
Hub
Shift Rod
Assembly
Sprocket
Spacer
Pin
Friction Wheel
Assembly
Shaft
Support
Bracket