Weider WESY85201 - Manual (Page 15)

15
32. Press a 1 3/4” Square Inner Cap (44) into the
Press Adjustment Tube (79).
Align one set of holes in the Press Adjustment
Tube (79) with the holes in the Rocker Arm
(32). Insert the “L”-Pin (40) through the holes.
Be sure that the Press Adjustment Tube is
oriented as shown.
Attach the Press Plate (78) to the Press
Adjustment Tube (79) with a 5/16” x 2 1/2”
Bolt (22), two 5/16” Flat Washers (8), and a
5/16” Nylon Locknut (3).
33. Press a 3/4” Round Inner Cap (34) into each
end of the Short Pad Tube (28). Press a 3/4”
Round Inner Cap into each end of the Long
Pad Tube (80).
Insert the Short Pad Tube (28) into the Seat
Frame (36). Slide a 5 1/2” Pad (30) onto each
end of the Short Pad Tube.
Insert the Long Pad Tube (80) into the Leg
Lever (29). Slide a 5 1/2” Pad (30) onto each
end of the Long Pad Tube.
34. Remove the backing from the 8520 decal and
apply it to the home gym system as shown.
Make sure that all parts have been properly
tightened. The use of the remaining parts will
be explained in ADJUSTMENT, beginning on
page 16 of this manual.
Before using the home gym system, pull each
cable a few times to be sure that the cables
move smoothly over the pulleys. If one of the
cables does not move smoothly, find and cor-
rect the problem. IMPORTANT: If the cables
are not properly installed, they may be
damaged when heavy weight is used. See
the CABLE DIAGRAM on page 19 of this
manual for proper cable routing. If there is
any slack in the cables, you will need to
remove it by tightening the cables. See
TROUBLE-SHOOTING AND MAINTE-
NANCE on page 18.
32
33
34
DECAL
PLACEMENT
SEA
T
ASSEMBL
Y
44
79
3 8
8
22
Slant must be
turned this way
32
40
78
36
28
80
34
34
30
30
30
29
8520