Weider WESY5984.1 - Manual (Page 9)

9
14. Insert the rod on the Backrest Frame (15) into the
slot in the Seat Carriage (12). Hold the Backrest
Frame vertically over the Seat Carriage and
slide the rod into the slot, as shown in the
inset drawing.
14
15
15
12
12
Rod
Slot
Rod
13. Attach the Backrest (14) to the Backrest Frame
(15) with four 1/4" x 45mm Screws (58).
13
15
58
14
12. Attach a Plastic Foot (53) to the Backrest Frame
(15) with an M4 x 16mm Screw (62).
Attach the two Guard Plates (17) to the inside of
the Backrest Frame (15) with four M4 x 16mm
Screws (62).
12
53
62
15
17
62
62
17
15. Attach the two 10-pound Short Resistance Bar
Caps (20) to the 10-pound Center Resistance Bar
(44) with two M4 x 12mm Flat Head Screws (85).
Attach the two 10-pound Resistance Bar Caps
(101) to the 10-pound Removable Resistance Bar
(67), the two 20-pound Resistance Bar Caps (88)
to the 20-pound Removable Resistance Bar (36),
the four 80-pound Resistance Bar Caps (100) to
the two 80-pound Resistance Bars (95), and the
two 40-pound Resistance Bar Caps (79) to the
40-pound Resistance Bar (96) with ten M4 x
12mm Flat Head Screws (85).
15
79
88
101
20
100
67
36
95
96
85
85
85
85
85
44