Weslo WLTL19010 - Manual (Page 8)

DIAGRAM OF THE CONSOLE
Clip
Key
Speed Control Water Bottle Holder
(Water bottle is
not included)
Note: If there is a thin sheet of clear
plastic on the console, remove it.
Monitor Display
STEP-BY-STEP CONSOLE OPERATION
Before the console can be operated, two “AA”
batteries must be installed (see assembly step 7 on
page 6).
Step onto the foot pads on the treadmill. Find the clip
attached to the key (see the drawing above), and slide
the clip onto the waistband of your clothing. Next, in-
sert the key into the console. Test the clip by care-
fully taking a few steps backward until the key is
pulled from the console. If the key is not pulled
from the console, adjust the position of the clip as
needed. Then, remove the key from the console.
Follow the steps below and on page 9 to operate the
console.
Insert the key fully into the power switch.
Note: Inserting the key
will not turn on the dis-
play. The display will
turn on when the
ON/RESET button is
pressed or when the
walking belt is started.
(If you just installed
batteries, the display will already be on.)
1
CAUTION:
Before operating the
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing
above) while operating the treadmill. When
the key is removed from the console, the
walking belt will stop.
• Adjust the speed in small increments.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and use only a sealable
water bottle.
8