Wegener Communications Unity Satellite Receiver Model Unity Synchronous Data Option - Manual (Page 4)

UTY4000-007 4
REPORT COMMOND is “r p.” The report will show if any sync data cards are
available. The line will read as follows:
Sync Data Card #(1 or 2): INSTALLED
The SYNC DATA report command is “r sd.” The report will report the sync data
card status in the following form:
FUNCTION CURRENT SETTING
RS422 OUTPUT ENABLED/DISABLED
LVDS OUTPUT ENABLED/DISABLED
SYNC DATA RATE data rate
PID PID
STATUS
3.2 From Front-panel
Ÿ
Sync Data Card setup with local control disabled:
The sync data card setup cannot be accessed via the front panel with local control
disabled. The Network must authorize local control.
Ÿ
Sync Data Card setup with local control enabled:
The sync data card can be set via the front panel, if local control is enabled, by using the
menu path HARDWARE SETUP / CONTROL SYNC DATA. Select the parameter you
need to adjust by using the right/left arrows and the <SELECT> key. Use the up/down
arrows to select the desired setting. Press the <ENTER> key to initialize the settings.
Ÿ
Sync Data Card status: To confirm that the Sync Data card option is available via the
front panel follow the menu path STATUS REPORTS / PARAMETER STATUS. Use the
right/left arrow keys to scroll to SYNC DATA.
To view how the sync data card is configured via the front panel follow the menu path
STATUS REPORTS / SYNC DATA STATUS. Use the right/left arrow keys to scroll
through the audio ports configuration.