Wells B-40 - Manual (Page 12)

TROUBLESHOOTING SUGGESTIONS
10
SYMPTON POSSIBLE CAUSE SUGGESTED REMEDY
Won’t heat- - no indicator
lights Not plugged in, or
Circuit breaker tripped. Check plug
Check / reset circuit breaker
One or more section
won’t heat—or not hot
enough
Temperature control not set
Set temperature control knob to
desired temperature
240V unit run on 208V Verify proper voltage
Damaged component or wiring
Contact an Authorize Wells
Service Agency for repairs
Temperature control not set
Set temperature control knob to
desired temperature
208V unit run on 240V Verify proper voltage
Damaged component or wiring
Contact an Authorized Wells
Service Agency for repairs
Element assy loose, or
difficult to raise or lower Damaged hinge
(see page 7 for precautions) Contact an Authorized Wells
Service Agency for repairs
Element assy does not
latch in up position Damaged support rod assembly
Contact an Authorized Wells
Service Agency for repairs
One or more section too
hot