Warning – Wayne-Dalton 8000 SERIES 46 User Manual

Page 29

Advertising

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the

Find a Dealer section online at www.wayne-dalton.com

Tools Needed:

INST

All

ATION

Place vice clamps onto both vertical
tracks just above the third roller. This is
to prevent the garage door from raising
while winding counterbalance spring(s).

fAILuRE TO PLACE VICE CLAMPS

ONTO VERTICAL TRACk CAN

ALLOW DOOR TO RAISE AND

CAuSE SEVERE OR fATAL

INjuRy.

IMPORTANT: DO NOT uSE IMPACT GuN
TO WIND SPRING(S).

Securing Door

for Spring winding

TRACk

VICE CLAMPS

ATTAChED TO

INNER RAIL

Of TRACk

(2) Vice Clamps

Locking Pliers

flat Tip

Screwdriver

Wire Cutters

Rotate the cable drum until the set
screw faces directly away from the
header. TorqueMaster

spring tube cam

peak should be pointing straight up.

Beginning with the right side, loosen
the set screw approximately two turns,
to adjust cable. using locking pliers,
pull on the end of the cable to remove
all cable slack.

Check to ensure the cable is aligned
and seated in the first groove of the
cable drum. Snug the set screw, then
tighten an additional 1-1/2 turns. Cut
excess cable.

Cable Adjustments

PLACE VICE

CLAMPS ABOVE

3RD ROLLER

COuNTERBALANCE

CABLE

SET SCREW

CABLE

DRuM

CAM PEAk

STRAIGhT uP

wARNINg

Advertising