Installation requirements, Tools and parts, Location requirements – Whirlpool W10203506A User Manual
Page 2
2
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
■
Phillips screwdriver
■
Measuring tape
■
Hand or electric drill (for wall cabinet installations)
■
1" (25 mm) drill bit (for wall cabinet installations)
■
Level
Parts needed
■
UL listed or CSA approved conduit connector
■
UL listed wire connectors
Parts supplied
■
0.188 x 2.1" screws - single oven (4), double oven (6)
Check local codes. Check existing electrical supply. See
“Electrical Requirements.”
It is recommended that all electrical connections be made by a
licensed, qualified electrical installer.
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
■
Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance with oven.
■
Recessed installation area must provide complete enclosure
around the recessed portion of the oven.
■
Grounded electrical supply is required. See “Electrical
Requirements” section.
■
Electrical supply junction box should be located in the upper
right corner, 4" (10.2 cm) below the upper cut out surface of
the cabinet.
■
Oven support surface must be solid, level and flush with
bottom of cabinet cutout. Floor must be able to support a
single oven weight of 154 lbs (70 kg) or a double oven weight
of 287 lbs (130 kg).
Product Dimensions - Single Oven
Cabinet Dimensions - Single Oven
Single Oven Installed in Cabinet
A. 22
¹⁄₄" (56.5 cm) max. recessed width
B. 29
⁵⁄₈" (75.3 cm) max. overall height
C. 23
⁷⁄₈" (60.6 cm) overall width
D. 22
⁵⁄₈" (57.5 cm) max. recessed depth
E. 27
⁷⁄₈" (70.8 cm) recessed height
A.
24" (61 cm) min. cabinet width
B. 1
¹⁄₂" (3.8 cm) top of cutout to bottom of upper cabinet
door
C. 33
¹⁄₄" (84.5 cm) min. bottom of cutout to floor
D. 22
³⁄₈" (56.8 cm) cutout width
E. 1
¹⁄₂" (3.8 cm) min. bottom of cutout to top of cabinet door
F. 28
¹¹⁄₁₆" (72.9 cm) cutout height
A
B
C
D
E
A
B
C
D
E
F