Weider 831.150850 - Manual (Page 6)

6
Before beginning assembly, carefully read the
following information and instructions:
• Place all parts in a cleared area and remove the
packing materials; do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• For help identifying the small parts used in
assembly, use the PART IDENTIFICATION
CHART on the page 5.
• As you assemble the weight bench, be sure that
all parts are oriented as shown in the drawings.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE
REQUIRED FOR ASSEMBLY:
• Two (2) adjustable wrenches
• One (1) rubber mallet
• One (1) standard screwdriver
• Lubricant, such as grease or petroleum jelly
plus soapy water.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches or a set of ratchet wrenches.
2
1
1. Before assembling this product, be sure that
you have read and understand the information
in the box above.
Position the Crossbar with the warning decal facing
up as shown. Attach the Crossbar (3) to Upright A
(1) with two M10 x 70mm Bolts (26), a Support
Plate (14) and two M10 Nylon Locknuts (30).
The
Upright must be oriented as shown.
Attach the Crossbar (3) to Upright B (15) in the
same manner.
2. Attach the Front Leg (8) to the Frame (2) with three
M8 x 16mm Bolts (28) and three M8 Washers (17).
Assembly
26
14
14
26
3
15
30
8
28
28
17
2
17
1