Wagan DC to AC Pure Sine Inverter 2601 - Manual (Page 3)

Elite ™ 400W Pro Pure Sine Inverter by Wagan Tech ®
www.wagan.com
3
©2012 Wagan Corporation. All Rights Reserved.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
4
User’s Manual—Read before using this equipment
FRONT PANEL
AC Outlet
Power LED Fault LED On/Off Switch
AC Outlet
USB Power Port
• ON/OFF Switch — This switch controls AC output of the inverter.
• Operating LED (Green) — When this green LED is lit, the inverter is operating
normally.
• FAULT LED (Red) — The RED indicator turns on as the inverter shuts down due to
overheating, overload, under voltage, or over voltage.
Immediately turn off all AC appliances if the FAULT LED is lit. Allow the
inverter to cool before continuing. Make sure that the ventilation vents
are not blocked.
If an inverter shutdown was preceded by a buzzing sound, there may be
an excessive load in combination with a low voltage or cable problem.
• AC Outlets — These outlets can supply up to 3.3 amps at 120V AC 60 Hz
• USB Power Port — This power port can supply 5 volts at 2.1A for charging or
powering smartphones, tablets and e-readers, MP3 players, GPS and other
small electronic devices.
• Audible Alarm (internal to the inverter) — When the Audible Alarm makes a
buzzing sound, the inverter senses a low battery condition. The user should
reduce the AC load, charge the battery, and check the DC cable for excessive
losses.
REAR PANEL
Cooling Fan
Negative (−)
Terminal
[Black]
Postive (+)
Terminal
[Red]
Ground
Terminal
• Positive Terminal — Positive (+) DC Input (Red)
• Negative Terminal — Negative (−) DC Input (Black)
• Cooling Fan — High-speed and load controlled
• Ground Terminal — For attaching an insulated safety ground wire. This safety
wire is for protecting personnel if there is an unlikely failure in either the cabling
or enclosure insulation.