White LC-436 - Manual (Page 14)

14
• Turn the lower handle around so the notch on the bottom of the lower handle is facing forward as shown in
Figure 10. Reassemble, placing the bottom holes in the handle over the weld pins in the handle mounting
bracket.
FIGURE 10
• Reassemble the upper handle to the lower handle.
• Place the hairpin clips in the inner holes in the weld pins and attach the starter rope as instructed in the
Assembly section.
Adjusting Cutting Height
IMPORTANT: All wheels must be placed in the same relative position. For rough or uneven lawns, move the height
adjustment lever to a higher position. This will help stop scalping of the grass.
An adjusting plate and thumb lever at each wheel position provides cutting height adjustment. Each adjusting plate
has nine height positions. Height of cut will be changed when the thumb lever is moved from one hole to another.
• Simply depress the lever towards wheel and move lever assembly to desired position. See Figure 11.
• For rough or uneven lawns, move the height adjustment handles to higher cutting height position.
FIGURE 11
• Remove the screw shown in Figure 11. Remove the cable clamp from the cable.
• Push the throttle control lever on the handle all the way forward as far as it will go, then back it off one "click".
Make certain the throttle control lever remains in this position.
• Push the control lever on the engine as far toward the rear of the engine as it will go.
• Secure the cable in this position with the cable clamp and screw.
Notch
Lower
Handle
Height
Lever
Adjustment