Wells WM-TR - Manual (Page 15)

PRECAUTIONS: Water in tank is EXTREMELY HOT (± 200ºF)
Turn Water-Max™ OFF and allow to cool
Tank full of water is HEAVY (64 lbs.)
Drain water from tank before moving.
FREQUENCY: Weekly, or as required when Water-Max™ will not
maintain water at 197ºF or higher.
TOOLS: Goggles, Chemical Resistant Gloves
LIMESHIELD™ Scale and Food Soil Inhibitor
Solution Bottle
Scrub Pad (Standard Green)
1. Power switch is located on right side of Water-Max™ base.
Press POWER SWITCH to OFF.
Drain 1 GALLON of water from TANK.
2. Examine SOLUTION BOTTLE for serviceability. If it is cracked or
distorted, replace it with a new bottle.
Pour 2.5 ounces of LIMESHIELD™ into solution bottle.
Slowly add 4 ounces of warm tap water.
DISPENSER CAP is attached to the top of Water-Max™ with a
chain. Screw quick-disconnect dispenser cap onto solution bottle.
Gently shake solution bottle. Allow solution to completely
dissolve.
IMPORTANT: Delime with LIMESHIELD™ Scale and Food Soil
Inhibitor ONLY!
3. QUICK-DISCONNECT FITTING is located on the left top of Water-
Max™.
Invert solution bottle. Insert bottle quick-disconnect fitting into
Water-Max™ quick- disconnect fitting. Press solution bottle down
until fitting “clicks”, locking solution bottle in place.
CAUTION
Burn Hazard
Water in Water-Max™ is
EXTREMELY HOT
CAUTION
Chemical Burn
Hazard
Deliming chemicals are
caustic.
Wear protective goggles and
gloves during this procedure.
DELIMING INSTRUCTIONS
HOT
1
GAL
ON
OFF
INSTALL QUICK-
DISCONNECT
INSERT
BOTTLE
13